10 Ton Coupler Gear Bearing Hydraulic Puller

The bearing puller is a device that takes out the inner bearing from the bearing seat. It is a built-in bearing puller, which includes a mounting plate, tension bolts and thread bolts; there are no less than two tension bolts, each tension force The bottom of the bolt is provided with a pulling claw that can hang the bottom of the built-in bearing, a fastening nut is installed on each tension bolt, and there is no less than one long hole in the middle of the mounting plate, and the width of the long hole is larger than the diameter of the tension bolt. The lower end of each tension bolt passes through the long hole and extends below the mounting plate, and the fastening nut can be clamped on the mounting plate at the long hole; no less than two positioning nuts are fixed on the mounting plate outside the long hole .Hydraulic Cable Puller main products   Company Information   

Thin Tape hydraulic jack Double acting hydraulic jack Large tonnage hydraulic jack PLC synchronous jacking system Three-dimensional Lifting Jack